Angle Adjustment Of The Contracture Footplate; Contracture Footplate Depth Adjustment - Invacare Solara Spree GT Owner's Operator And Maintenance Manual

SECTION 14—CONTRACTURE FOOTPLATE OPTION
1. Press the button on the quick-release
pin and insert through the contracture
support and the angle adjustment
bracket.
2. If necessary adjust the angle of the
contracture assembly. Refer to
Contracture Assembly Angle
Adjustment on page 87.

Angle Adjustment of the Contracture Footplate

NOTE: For this procedure, refer to
FIGURE 14.5.
1. Loosen, but DO NOT remove, the two
flat screws, washers and locknuts that
secure contracture footplate to the
footplate hinge.
2. Tilt the contracture footplate up/down
to achieve desired angle.
3. Retighten the two flat screws, washers
and locknuts that secures the
contracture foot plate to the footplate
hinge.
4. If necessary, repeat STEPS 1-3 on
remaining contracture footplate.

Contracture Footplate Depth Adjustment

NOTE: For this procedure, refer to FIGURE 14.6 on page 89.
NOTE: Observe the angle of the contracture footplate for reinstallation.
1. Perform one of the following:
• Bilateral Contracture - Remove the two flat screws, washers and locknuts that
secure the contracture footplate to the footplate hinge.
• Contracture Platform - Remove the four flat screws that secure the contracture
platform to the half clamps.
2. Move the contracture footplate to one of four mounting hole.
® ™
Solara /Spree GT
Pop Rivet
Button
Quick-Release Pin
FIGURE 14.4 Using the Optional Quick-
Release Pin
Contracture
Assembly
Footplate
Hinge
NOTE: Mounting
hardware removed
for clarity only.
NOTE: Bilateral contracture footplate
shown for clarity.
FIGURE 14.5 Angle Adjustment of the
Contracture Footplate
88
Angle
Adjustment
Bracket
Contracture
Support
Flat Screws
Contracture
Footplate
Washers
Lock Nuts
Part No 1125027