Section 6-Front Riggings; Installing/Removing Swingaway Footrest; Installing; Removing - Invacare Solara Spree GT Owner's Operator And Maintenance Manual

SECTION 6—FRONT RIGGINGS
After ANY adjustments, repair or service and BEFORE use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may occur.

Installing/Removing Swingaway Footrest

NOTE: For this procedure, refer to FIGURE 6.1.

Installing

1. Turn the footrest to the side (open footplate is perpendicular to the wheelchair).
2. Insert the front rigging assembly mounting pin into the mounting tube of the
wheelchair frame.
3. Rotate the footrest towards the inside of the wheelchair until it locks into place.
NOTE: The footplate will be on the inside of the wheelchair when locked in place.
4. Repeat STEPS 1-3 for the other footrest assembly.
5. If necessary, adjust the footrest height. Refer to Adjusting Footrest Height on page 34.

Removing

1. Push the footrest release lever inward while rotating the front rigging outward.
2. Lift the footrest assembly out of the mounting pin of the wheelchair frame.
3. Repeat STEPS 1-2 for opposite side, if necessary.
Footrest Release Lever
Wheelchair Frame
NOTE: Only 60° Footrest
shown for clarity. Others will
attach the same way.
FIGURE 6.1 Installing/Removing Swingaway Footrest
Part No 1125027
WARNING
Mounting Pin
Mounting Tube
SECTION 6—FRONT RIGGINGS
33
Footrest Assembly
Footplate
® ™
Solara /Spree GT