Table of Contents
Advertisement
Moreover, all LAN ports teamed together must be set in the same mode. For example, suppose
the LAN port 1 and LAN port 2 is in Trunking mode already, and you configure the LAN port 3 in
"Fail-over" mode, then all LAN ports will be switched to "Fail-over" mode.
Or, if a network has more than two subnets, system administrator can setup each network card
separately into different subnet IP address to achieve the "Load Balancing" effect.
Note: If these LAN ports are not configured in "Fail-over" mode, you must assign three IP
addresses in different subnet to the cards respectively, thus when choosing network type
through DHCP, please make sure if the subnet has any DHCP server available for use.
Routing table tab
Use this page to configure the routing table. To add a new route, please enter the gateway in the
"Gateway" field. You can select "Default gateway" or enter appropriate data in the "IP address" or
"Subnet/Mask" fields, then click "Create" button. After finish adding all route records, click "Apply"
button to save the configuration.
4.2.2 Date Setup
32
Advertisement
Table of Contents
