Planet NAS-5400 User Manual page 16

domain name, subnet mask, gateway, and DNS server. The setup program will get the
network configuration for your reference. If the information is not enough, click on Suggestion;
the setup program will check available IPs on the LAN and provide a suggested IP address.
6. Click Apply to confirm the network settings. The program will automatically activate the
browser and connect to the server's IP address, then start the Quick Configuration.
If the NAS-5000 series Assistant cannot locate your NAS-5400 or fails to setup, please verify
followings before trying again.
1. Make sure the power cord is attached and the server is start up successfully.
2. Make sure the server has an active LAN connection. You can verify it by checking the LAN
LED status on the panel of NAS-5400.
3. Make sure the managed computer (which is running NAS-5000 series Assistant) and the
NAS-5400 are physically in the same LAN.
4. Make sure the managed computer has installed and set the TCP/IP protocol, and is running
Microsoft Internet Explorer 5.0 or above.
5. Make sure the selected server name is correct.
6. Make sure the LAN still has valid IP addresses.
10