Remote Control - Christie Mirage S+ User Manual

Section 6: Specifications
6-4
DVI-I Input
Interface Standard
Signal Types
Color Space
Horizontal Frequency Range
Vertical Frequency Range
Pixel Clock Rate
Scan Format
Active Pixels per scan line
Active Lines per field / non-interlaced frame
Connector type
NOTE: HDCP compatible. (
RS-232 Serial Input
Connector Type
RS-422 Serial Input
Connector Type
GPIO
Connector Type
Number of I/O lines
Power Output
Output sink current (logic low)
Ethernet
Connector Type
Maximum throughput

Remote Control

Number of sensors
Type
Range (using std. keypad)
Battery type (2 required)
Laser Diode (laser pointer)
Wired Control
Connector type
Input levels
Mirage S+/HD/WU, Matrix S+/HD/WU, Christie HD/DS+/DW, DLV User Manual
DDWG DVI 1.0
- RGB (Analog or Digital
- YPbPr (Analog)
- YCbCr (Digital)
RGB or YPbPr
31 – 120 kHz
23.97 – 150 Hz
25 – 165 MHz
interlaced or progressive
640 min., 2048 max.
200 min., 1536 max
DVI-I
Not supported in v1.1 s/w)
One female 9-pin Dsub (RS232 IN)
One male 9-pin Dsub (RS232 OUT)
One female 9-pin Dsub
One male 9-pin Dsub
7
(each individually assignable as input or output)
+12VDC @ 200mA max.
100mA @ 1V
One female RJ45
115.2kbps
Two
IR with wired ability
100 feet
AA, 1.5 V Alkaline
Wavelength 670nm
Max. Output 1mW
3.5mm RCA jack
High: 2.2 V – 5.6 V (or open)
Low: -0.6 V – 0.9 V @ 1 mA
020-100001-07 Rev. 1 (11-2009)