Christie Mirage S+ User Manual page 112

Section 4: Maintenance
4-6
Table 4.2. Lamp/Filter Replacement Kits
Projector Model Model Number
Mirage S+3K 38-DSP102-xx
104-012101-xx
Mirage HD3
Christie HD3K 104-025101-xx
Mirage WU3 104-060107-xx
Christie HD2Kc 104-026101-xx
Matrix S+2K 38-DSP102-xx
104-023101-xx
Matrix HD2
Matrix WU2 104-058104-xx
DLV1400-DX 38-DSP102-xx
104-017101-xx
DLV1920-DX
Christie DS+6K 38-DSP104-xx
Christie DS+5Kc 38-DSP104-xx
Christie DW4Kc 38-DHD103-xx
Christie DW5K 38-DHD103-xx
Christie HD6K 104-006101-xx
Christie HD5Kc 104-007101-xx
Mirage HD6 104-013101-xx
38-DSP104-xx
Mirage S+6K
Mirage WU7 104-061108-xx
Matrix 4000 38-DSP104-xx
Matrix S+5K 38-DSP104-xx
Matrix HD4 104-016101-xx
104-059105-xx
Matrix WU5
Christie DS+8K 38-DSP106-xx
Christie DW6Kc 38-DHD106-xx
38-DHD106-xx
Christie DW8K
Christie HD8K 104-008101-xx
Christie HD7Kc 104-018101-xx
Matrix HD7 104-024101-xx
A lamp should be replaced when it reaches its end of life or sooner if a noticeable
degradation in brightness occurs (typical in aging lamps). You can set the number of
hours you expect to log with the lamp before replacing it, by setting the Lamp Limit
in the Lamp menu. The LED's next to the built-in keypad will flash "LP" when lamp
time has expired. You can also enable a warning message to appear upon powering up
the projector that will indicate the lamp has reached the limit you set, by entering a
checkmark beside the Lamp Message option.
NOTE: The lamp mode you choose to run the projector in may have an impact on the
number of hours expected for the lamp.
Tools required: #2 Phillips screwdriver
Warnings
A qualified service technician must perform lamp replacement.
Cool the lamp completely and handle by the housing only.
Install the correct wattage lamp supplied by Christie (see above) and read the
Lamp Replacement procedure in its entirety before proceeding.
Do not touch the glass surface of the lamp. Fingerprints left on the surface can
lead to an intense accumulation of heat called a "hotspot", which could
potentially result in the lamp shattering. It is recommended you wear clean, lint-
free gloves and a face shield when working with the lamp.
Mirage S+/HD/WU, Matrix S+/HD/WU, Christie HD/DS+/DW, DLV User Manual
Lamp Type (Watts) Lamp/Filter Kit Required
500W
1000W
1200W
003-120118-01
003-120117-01
003-120116-01
020-100001-07 Rev. 1 (11-2009)