Christie Mirage S+ User Manual page 115

Mirage S+/HD/WU, Matrix S+/HD/WU, Christie HD/DS+/DW, DLV User Manual
020-100001-07 Rev. 1 (11-2009)
Improper installation could cause a serious
7. LOCK IN THE NEW LAMP MODULE
Pull out and turn the lamp lock lever (turned up in Step 4) ¼ turn clockwise to
"lock" the lamp in place.
NOTE: If you can't turn the lamp lock into position, it is likely the lamp is not
fully inserted. In this case, partially remove the lamp and try pushing it back in
again. Then, try switching the lock lever to the "lock" position.
8. REPLACE THE LAMP DOOR
Replace the lamp door and secure it with the two (2) screws removed in Step 2.
IMPORTANT: The lamp module is calibrated for maximum performance and
brightness in this projector. Do not attempt to re-align or adjust the lamp module.
9. RECORD THE SERIAL NUMBER OF THE NEW LAMP

Plug in the projector and power it up.

In the Lamp menu, select "Change Lamp".

In the Lamp S/N text box, enter the serial number.

Press to record the number and to reset the lamp timer. The timer will now
begin to log time for the new lamp.
Figure 4.5. Insert New Lamp Module
WARNING
meltdown inside the projector.
Section 4: Maintenance
4-9