Christie Mirage S+ User Manual page 23

YPbPr Signals 
(COMPONENT VIDEO)
Mirage S+/HD/WU, Matrix S+/HD/WU, Christie HD/DS+/DW, DLV User Manual
020-100001-07 Rev. 1 (11-2009)
Figure 2.7. Connecting RGB and Sync
NOTES: 1) If for some reason the projector fails to recognize a signal as an RGB
signal, specify this Color Space option within the Image Settings menu. See 3.5
Adjusting the Image. 2) To connect YPbPr signals–such as from DVDs or analog HDTV
sources–to , use the red, green and blue BNCs as described in YPbPr Signals
INPUT 1
(below).
Connect an YPbPr signal (component video) to
2.8.
NOTES: 1) If, for some reason, the projector fails to recognize an YPbPr signal,
specify this Color Space option within the Image Settings menu. See 3.5, Adjusting
the Image. 2) Do not connect digital component signals (known as YCbCr) to
. Install an appropriate optional module in
1
Figure 2.8. Connecting YPbPr sources
Section 2: Installation and Setup
or as shown in Figure
INPUT 1 INPUT 2
or for this.
INPUT 5 INPUT 6
INPUT
2-13