Christie Mirage S+ User Manual page 71

System Configuration 
— COMMUNICATIONS —
Mirage S+/HD/WU, Matrix S+/HD/WU, Christie HD/DS+/DW, DLV User Manual
020-100001-07 Rev. 1 (11-2009)
SPLASH SCREEN SETUP —
display a special introductory splash screen image, such as your company logo,
graphic or message.

Always Off = A splash screen never appears

Always On = A splash screen is always on behind the current display image,
similar to wallpaper.

Start-up Only – The splash screen logo appears at projector start-up only.

Start-up And No Signal – A splash screen appears at start-up only if there is no
source signal.
To replace the default "Christie logo" splash screen (or other) with one of your own,
use KoRE Librarian to download the desired .bmp to the projector. This will
overwrite the current splash screen content in projector memory.
Settings in the Communications
submenu define and control how
single or multiple projectors are
linked with each other and with
a controlling device.
Baud Rates
The baud rate setting determines
the speed of communication to
and from the projector on the
RS232 or RS422 links. The
maximum rate for the RS232 is
115200; for RS422 it is 19200.
Set the baud rate to match that
of your controlling device, such as your PC. If you are unsure about what baud rate to
choose, refer to the documentation for the controlling device. In an existing network
of projectors, if you discover that a projector has a different baud rate, use the pull-
down list and select the correct baud rate using the
control with or
parity.
Projector
Enter a three-digit number (such as "001") to assign or change a number to the
projector currently in use. If the current projector already has a number assigned, that
number will appear here (for example, "004" in the menu shown above). Numerical
identity for projectors enables you to communicate with a single projector within a
multiple-projector application (see also
make a mistake in assigning or changing the projector number, press
NOTE: When multiple projectors are being used and you want to adjust the color and
edge blending settings for individual projectors to create one seamless image, you
must assign different numbers for each projector to allow switching back and forth
between projectors while adjustments are being made.
Use the Splash Screen to choose when you would like to
Baud Rate for RS232
1.
2. Baud Rate for RS422
3.
Network Routing
4.
5. Ethernet Settings
6. Broadcast Key
7.
8.
9.
Wired Keypad
0.
keys. Serial communication is always eight data bits, no
key in 3.2, Using the Keypads). If you
Proj
Section 3: Operation
Communications
115200
19200
Projector
004
All Joined
Backlight
Front IR On
Back IR On
Off
key—do not just scroll this
Exit
to cancel.
3-41