Wall Mount; Phone Startup Verification; Network Settings Without Dhcp - Cisco 3905 Administration Manual

Wall mount

Wall mount
You can mount the Cisco Unified SIP Phone 3905 on the wall by using a standard telephone wall plate with
an opening for an RJ-45 connector. Cisco recommends that you use Leviton Wall Mount plate (Leviton type
number: 4108W-0SP) to wall mount the Cisco Unified SIP Phone 3905. For information on installing the
wall mount kit for Cisco Unified SIP Phone 3905, see

Phone Startup Verification

The LEDs on the MWI on the phone light up during bootup. Upon successful completion of the bootup process,
the LEDs turn off, and the phone is ready for calls. If the phone successfully boots up, it has started up properly.
If the phone does not start up properly, the user receives a notification on the phone screen. For more
information, see the

Network Settings Without DHCP

If you are not using DHCP in your network, you must configure these network settings on the
Cisco Unified IP Phone after installing the phone on the network:
• IP address
• IP subnet information
• Default Router
• TFTP server IP address
Collect this information and see the instructions in
Cisco Unified SIP Phone 3905 Administration Guide for Cisco Unified Communications Manager 8.6 (SIP)
34
Startup Problems, on page 79.
Cisco Unified IP Phone Installation
Items Required for Wall Mount, on page
Cisco Unified IP Phone Settings, on page
111.
35.