MINOLTA-QMS PagePro 9100 User Manual page 88

Symptom
The printer is
not receiving
data from the
computer.
(The Data
indicator
doesn't blink
after a file is
sent.)
Too many
status pages
print.
In the
Security
menu with
Enable
Password
set, a telnet
session asks
for a pass-
word when
entering the
admin mode.
82
Cause
The printer is not on
line.
The emulation has
been changed from
ESP to an emulation
that doesn't match
the file you are
sending.
The port setting is
incorrect.
When the parallel
cable is set to Inter-
active (the default),
and the parallel cable
is unplugged then
plugged back in,
communication was
lost.
Your printer is set to
print the multiple-
page Advanced
Status Page instead
of the one-page
Standard Status
Page.
In the "Security/
Admin Menu" menu,
the password you set
will affect both the
admin mode and the
Admin Menu.
Solution
Put the printer on line and verify that the
message window displays IDLE.
Print a status page. For information
about the ESP mode, refer to the
CrownBooks in PDF on the Documenta-
tion CD-ROM.
For Ethernet, parallel, or USB
connections, set the port to Enabled.
Set the parallel cable to Non-
Interactive mode in the Administration/
Communications/Parallel/Mode menu.
Select the type of status page through
the Administration/Special Pages/
Status Page Type menu on the control
panel.
Use the password you set for the
Security/Admin Menu for the telnet admin
mode.
Solving Problems