MINOLTA-QMS PagePro 9100 User Manual page 130

Installing an Internal IDE Hard Disk Drive
Attention
It's very important to protect the printer controller board and any
associated circuit boards from electrostatic damage. Before performing
this procedure, review the antistatic caution on page 108. In addition,
always handle circuit boards by the edges only.
When installing or removing a hard disk, make sure that the metal
support posts (on the hard disk) does not come in contact with any of
the electrical leads on the chips mounted on the controller board. The
controller board will not function if any of the leads are broken or
shorted together.
1
Turn off the printer, and then disconnect the power cord and all interface
cables from the printer.
2
Remove the controller board.
Loosen four screws, and pull
the controller board
from the printer.
3
Position the controller board
on a flat surface so it lies flat
and the I/O connector panel
is facing you.
4
Position the controller board
on a flat surface so the con-
troller board lies flat and the
interface panel is facing you.
5
Attach the internal IDE hard
disk drive to the hard disk
bracket.
Attach the internal IDE hard
disk drive to the bracket with
the grooved-end of the bracket
facing the ribbon cable. The
screw holes in the bottom of
the hard disk should match up
with the holes on the hard disk
bracket. Fasten the hard disk
to the bracket with the screws
provided.
124 Internal IDE Hard Disk Drive