MINOLTA-QMS PagePro 9100 User Manual page 115

5 "
If you want to install more memory, you may exchange one or
more DIMMs for DIMMs with a greater memory capacity.
5
If you need to remove a DIMM before installing one, remove it as follows;
otherwise, skip to step 6.
a
Using both thumbs,
pull the latches (one
on each side of the
DIMM connector)
outward.
b
Lift the DIMM straight
out of the DIMM con-
nector.
6
Insert the new DIMM
straight down into the
DIMM connector until
the latches snap into
the locked position.
Observe the keyed
side of the DIMM to
align it with the con-
nector. When seated,
the DIMM stands
upright, firmly in place.
If you cannot snap the
DIMM into place, do
not force it. Reposition it, making sure that the bottom of the DIMM is
seated completely in the connector.
7
Reinstall the controller board into the printer.
Gently slide the controller board into the printer's tracks until it is fully
seated, and then tighten the four screws.
8
Reconnect all interface cables.
9
Reconnect the power cord, and turn on the printer.
5 "
In compliance with UL guidelines, "The appliance inlet is
considered to be the main disconnect device."
Dual In-Line Memory Modules (DIMMs)
109