Service Menu - MINOLTA-QMS magicolor 2300 DL User Manual

Auto Continue When set to On, the printer continues printing if the
Chaining
Tray (only
available if
optional Tray
2 [lower
feeder unit
media tray] is
present)
Change Toner
Sz (Size)
Replace Toner By selecting the color of the toner cartridge that you want to

Service Menu

Page Count
Controller Ver. The current controller firmware version
Engine Ver.
DIMM Test
SDRAM Test
Power On Test Performs an AIDC (Auto-Image Density Control) calibration
User Default
Selecting a Message Window Language
specified tray is not loaded with paper of the correct size.
The Auto Continue setting can also be changed while
printing. If this is done, the setting will remain valid for
future print jobs.
When set to On, the printer automatically switches to a
different media tray containing paper of the same size and
type and continues printing if the specified tray runs out of
paper.
When set to Off, the printer stops and displays a message
indicating that paper should be loaded into the specified
tray if the specified tray runs out of paper.
Use this submenu to change the toner cartridge capacity.
Yellow, magenta, and cyan toner cartridge sizes available
are standard capacity (1,500 pages) and high capacity
(4,500 pages). Black cartridges available are high capacity
(4,500 pages).
replace, the carousel is automatically repositioned so that
the selected toner cartridge can be removed. Refer to
"Replacing a Toner Cartridge" on page 53.
The number of pages that have been printed to date.
The printer engine firmware version
Allows you to verify the DIMM by performing a DIMM test.
Allows you to check that there are no errors in the SDRAM
cycle. Wait until the test is finished and IDLE/MAGICOLOR
2300DL is displayed (less than 150 seconds).
Resets the settings for Energy Saver, Auto Continue, and
Chaining Tray (if lower feeder unit is attached) to their
defaults:
Energy Saver: 30 minutes
Auto Continue: On
Chaining Tray: On
35