MINOLTA-QMS magicolor 2300 DL User Manual page 96

Symptom
Printing
takes too
much time.
Blank pages
come out
during a
printing job.
Printer
returned to
IDLE
before
the menu
was
changed.
Not all pages
print.
90
Cause
The printer is set to a
slow printing mode
(for example, thick
stock or
transparency).
The printer is set to
power saving mode.
The job is very
complex.
The printer memory is
insufficient.
One or more of the
toner cartridges are
defective or empty.
The wrong media is
being used.
The printer was in the
menu structure
without a selection
being made within
two minutes.
The printer has the
wrong kind of cable,
or the printer is not
configured for the
correct cable and
port.
The Cancel key was
pressed.
The media tray is
empty.
A document is printed
with an overlay file
which has been
created by a
non-magicolor 2300
DL driver.
Solution
It takes more time to print with special
media. When using regular paper,
make sure that the media type is set
properly in the driver.
It takes time for printing to start in
power saving mode. If you do not want
to use this mode, disable it.
Wait. No action needed.
Add more memory.
Check the toner cartridges. The image
does not print if the cartridges are
empty.
Check that the media type set in the
driver matches the media loaded in the
printer.
When in the menu structure, select
your choice before two minutes elapse.
Check your cable.
Make sure no one pressed the Cancel
key while your job was printing.
Check that the media trays are loaded
with media, in place, and secure.
Print the overlay file using a magicolor
2300 DL driver from the magicolor
2300 DL Utilities and Documentation
CD-ROM.
Solving Other Problems