Dial Backup And Leased Line Restore Setup - Multitech MultiModem II MT5600BA-V92 User Manual

Dial Backup and Leased Line Restore Setup

Connect a telephone cable to the LINE jack of an MT5600BA-V92 modem set up for leased line
1.
operation. Connect the other end of the cable to a standard dialup line jack.
Turn on the modem.
2.
Starting at the STATUS LCD, press the following buttons on the front panel: , , , , , , .
3.
The ENTER NUMBER LCD appears.
Press  or  several times to select the first digit in the dial backup telephone number.
4.
Press  to go to the next digit in the number.
5.
To backspace or to cancel an entry, press  several times.
Note:
Repeat steps 4 and 5 until the number is entered. The number can be up to 30 characters in length.
6.
Press Enter to store the number. The DIAL BACKUP # STORED LCD appears.
Press Enter again to go to the DIAL BACKUP NUMBER LCD.
7.
Note: Steps 8 through 15 are optional.
To change the default restore time, press  to go to the TIME TO RESTORE (S15) LCD, then press ,
8.
. The ENTER TIME IN MINUTES LCD appears.
Press  or  several times to select the first digit in the number.
9.
Press  to go to the next digit in the number.
10.
Repeat steps 9 and 10 until you have entered a value between 10 and 255, or 0 to disable dial
11.
backup, and then press Enter to store it. The TIME STORED LCD appears.
Press Enter to return to the TIME TO RESTORE (S15) LCD.
12.
To change the default dial backup time, press  to go to the DIAL BACKUP TIME (S17) LCD, then
13.
press , . The ENTER TIME IN MINUTES LCD appears.
Repeat steps 9 and 10 until you have entered a value between 0 and 255, and then press the Enter
14.
button to store it. The TIME STORED LCD appears.
Press Enter again to return to the DIAL BACKUP TIME (S17) LCD.
15.
Dial backup and leased line restore setup is complete.
Notes:
●
Registers S15 and S17 can also be changed using the Sr=n AT command. See the
Reference Guide for more information.
●
The dial backup number can be displayed only 16 characters at a time. To see characters 17–30,
press . To go to the previous LCD, press . To go to the next LCD, press .
Multi-Tech Systems, Inc. MT5600BA-V92 User Guide
Chapter 4 – Leased Line Operation
AT Command
29