Installing The Modem Driver - Multitech MultiModem II MT5600BA-V92 User Manual

Connect the phone to the modem (optional). For voice-only calls, plug a telephone into the
5.
modem's PHONE jack.
Connect the modem to the AC power outlet:
6.
a. Plug the power supply into an AC power outlet or power strip.
b. Plug the power supply's cable into the POWER jack on the modem.
Note: Use only the power supply supplied with the modem. Use of any other transformer voids
the warranty and can damage the modem.
Test the modem by turning it on (a power switch is located on the front panel).
7.
When you apply power, the modem performs a diagnostic self-test, indicated by the TM indicator
lighting for a few seconds, after which the LCD should light. If this does not happen, check that the
power switch is on, the power supply is solidly connected, and the AC outlet is live. If these
measures do not work, refer to Troubleshooting.

Installing the Modem Driver

If you use Windows 2000 or newer, you must install the modem driver.
Download the driver from the Multi-Tech Installation Resources website. To do this:
1.
a.
Go to
http://www.multitech.com/setup/product.go
down list.
b.
Click Drivers.
c.
Click the link for a driver and extract the files to a folder on your hard drive.
With your computer turned off, ensure that your modem is connected properly, and then turn on your
2.
computer. When it boots up, the computer should detect the modem and open the Found New Hardware
Wizard.
When prompts to let Windows connect to Windows Update, select No, not this time and click Next.
3.
Select Install from a list or specific location and click Next.
4.
Select Search for the best driver in these locations. Uncheck Search removable media.
5.
Check Include this location in the search.
6.
Click Browse and select the folder where you extracted the drivers.
7.
Click Next.
8.
Click Continue Anyway, if prompted.
9.
Click Finish to exit.
10.
Restart your computer if prompted.
11.
Multi-Tech Systems, Inc. MT5600BA-V92 User Guide
Chapter 3 – Using the Front Panel
and select your model from the Product drop
9