Cleaning Your Cooker; Daily Care; Cleaning For Spills; Cooktop Burners - Falcon 900S Dual Fuel User's Manual & Installation Instructions

6. Cleaning Your Cooker

Isolate the electricity supply before carrying out any major
cleaning. Allow the cooker to cool.
NEVER use paint solvents, washing soda, caustic
n n
cleaners, biological powders, bleach, chlorine based
bleach cleaners, coarse abrasives or salt.
DO NOT mix di erent cleaning products – they may
n n
react together with hazardous results.
Avoid using any abrasive cleaners including cream
n n
cleaners. For best results use a liquid detergent
cleaner.
All parts of the cooker can be cleaned with hot soapy water
– but take care that no surplus water seeps into the
appliance.
Remember to switch the electricity supply back on before
reusing the cooker.

Daily Care

Cleaning the cooker is not a welcomed chore, but it has to be
done to maintain e ciency and appearance. Remember it
is better to wipe up any spills as they occur, this will prevent
them burning on and becoming more di cult to remove
later.
Make sure the ow of combustion and ventilation
nn
air to the cooker is unobstructed – for example by
build-up of fats or grease.
On Natural Gas the burners ames should be a bluish color
with, at most, a slight yellowish fringe.
On LP gas the ames may be "softer". The hotplate burner
ames may have a slight yellowish tip.
If the ame burns with a long white tip you should call for
service.

Cleaning for Spills

For spills and boil-overs that occur while cooking, as soon as
possible turn o the burner and allow to cool. Do not clean
until the area is completely cooled down. Wipe up spills as
soon as possible.
Do not allow surplus water to seep into the cooker.
Hotplate Burners
The burner heads and caps can be removed for cleaning.
Make sure they are absolutely dry before replacing (Fig.6-1).
When replacing a burner head, make sure that it locates
properly within the base (Fig.6-2). If you look at the bottom
of the burner head you will see two 'pips' – these t into the
two notches in the burner base (Fig.6-3).
Check the burner ports are not blocked. If a blockage occurs,
remove stubborn particles using a piece of fuse wire.
A
ArtNo.311-0028 - Burner head off
B
ArtNo.311-0030 - Burner head fitting
ArtNo.311-0029 - Burner base & head alignment
13
A – Cap, B – Base
ArtNo.311-0028 - Flame
Fig.6-1
Fig.6-2
Fig.6-3