Overview; Hotplate Burners - Falcon 900S Dual Fuel User's Manual & Installation Instructions

2. Overview

Hotplate Burners

Before using the hotplate make sure all burners are in place
and all the pan supports on the cooker are properly placed.
The drawing by each knob indicates which burner that knob
controls (Fig.2-1).
Each burner has a Flame Supervision Device (FSD) that stops
the ow of gas if the ame goes out.
When a hotplate burner knob is pressed in, sparks will be
made at every burner – this is normal. Do not attempt to
disassemble or clean around any burner while another
burner is on. An electric shock could result.
To light a burner, push in and turn the associated control
knob to the high position indicated by the 'large ame'
symbol, (Fig.2-2).
The igniter should spark and light the gas. Keep holding the
knob pressed in to let the gas through to the burner for a few
seconds (Fig.2-3).
If, when you let go of the control knob, the burner goes out,
then the FSD has not been bypassed. Turn the control knob
to the OFF position and wait for one minute before you try
again, this time making sure to hold in the control knob for
slightly longer.
ArtNo.250-0004 - Falcon 900S hotplate layout
ArtNo.250-0001 - 90 DF - Falcon control to HIGH
ArtNo.250-0003 - Falcon control
3
knob push-in
Fig.2-1
Fig.2-2
Fig.2-3