Master/Slave - Chauvet Intimidator Spot XYZ User Manual

Master/Slave

This is the operating mode which will allow one fixture to act as the "master" and control all of the other
"slave" fixtures. You must set both the master and the slave(s) fixtures to the correct mode for this
operation.
Please see the diagram below on the connections for your fixtures, as well as the setting to assign in the
control panel.
It is not necessary to arrange the master fixture as the first fixture in the daisy chain. It
may be any fixture in the daisy chain. For example: fixture 2, 5, 10 or 12, etc.
Only 1 fixture may be set to master.
Do not connect a DMX controller to the daisy chain for this operating mode.
In order to mirror one fixture to another, you may invert the pan and tilt on the mirrored
fixture.
Set this fixture to either
4. Operating Instructions
or or
Set this fixture to
mode
Master
15
Set this fixture to
mode
Slave
mode
Slave
Additional signal
(DMX) link out
10/9/2009 2:29 PM