Signal Linking (Dmx); Fuse Replacement - Chauvet Intimidator Spot XYZ User Manual

Signal Linking (DMX)

The diagrams below illustrate the signal (DMX) linking for this fixture. This is used both in DMX mode
and when operating the fixtures in Master/Slave mode. Please see the diagram below for further
explanation.
(only in DMX operation)

Fuse Replacement

Disconnect the power cord before replacing a fuse and always
replace with the same type fuse.
With a flat head screwdriver unscrew the fuse holder out of its housing, turning counter-clockwise.
Remove the damaged fuse from its holder and replace with exact same type fuse. Insert the fuse
holder back in its place and reconnect power.
4. Operating Instructions
First fixture
DMX controller
The fuse is located
inside this fuseholder.
9
Second fixture Third fixture
Additional signal
(DMX) link out
10/9/2009 2:29 PM