Master/Slave Mode; Infrared Remote Control - Chauvet SlimPAR Quad 12 IRC User Manual

Master/Slave
Mode
Infrared Remote
Control
SlimPAR™ QUAD 12 IRC User Manual (Rev. 1)
The Master/Slave mode allows a single SlimPAR™ QUAD 12 IRC unit (the "master") to
control the actions of one or more SlimPAR™ QUAD 12 IRC units (the "slaves") without
the need of a DMX controller. The master unit will be set to operate in either Automatic
or Sound-Active mode, while the slave units will be set to operate in Slave mode. Once
set and connected, the slave units will operate in unison with the master unit.
Configure the units as indicated below.
Slave units:
1. Press <MENU> repeatedly until 4-CH or 8-CH shows on the display.
Press <ENTER> to accept.
2.
3. Set the DMX address to d 1.
4. Connect the DMX input of the first slave unit to the DMX output of the master unit.
5. Connect the DMX input of the subsequent slave units to the DMX output of the
previous slave unit.
6. Finish setting and connecting all the slave units.
Master unit:
1. Set the master unit to operate in either Automatic or Sound mode.
2. Make the master unit the first unit in the DMX daisy chain.
• Configure all the slave units before connecting the master unit to the DMX
daisy chain.
• Never connect a DMX controller to a DMX string configured for Master/Slave
operation because the controller may interfere with the signals from the
master unit.
• Do not connect more than 31 slave units to the master unit.
The SlimPAR™ QUAD 12 IRC is fully compatible with the Infrared Remote Control (IRC)
from CHAUVET®. To enable usage with the IRC, do the following:
1. Press <MENU> repeatedly until SET shows on the display.
Press <ENTER> to accept.
2.
3. Press <UP> or <DOWN> to select ON or OFF.
4. Press <ENTER>.
Page 13 of 17