Table of Contents
Advertisement
Master/Slave Connectivity
The Master/Slave mode allows an COLORado PXL Bar 16 (the master) to control one or more
COLORado PXL Bar 16 products (the slaves) without a DMX controller. One COLORado PXL Bar 16
becomes the master when running an auto program, or by being in Static mode.
You must configure each slave's control panel to operate in Slave mode. During Master/Slave operation,
the slaves will operate in unison with the master.
DO NOT connect a DMX controller to products operating in Master/Slave mode. The DMX
controller signals may interfere with the signals from the master.
• The
Operation
the master and slaves.
• If you are not familiar with or need more information about DMX standards, or the DMX
cables needed to link this product to a DMX controller, download the DMX Primer from
the Chauvet website: www.chauvetprofessional.com.
Mounting
Before mounting the product, read and follow the safety recommendations indicated in the
For our CHAUVET Professional line of mounting clamps, go to http://trusst.com/products/.
Orientation
Always mount this product in a safe position, making sure there is adequate room for ventilation,
configuration, and maintenance.
Rigging
Chauvet recommends using the following general guidelines when mounting this product.
•
Before deciding on a location for the product, make sure there is easy access to the product for
maintenance and programming purposes.
•
Make sure that the structure onto which you are mounting the product can support the product's
weight. See the
Technical Specifications
•
When mounting the product overhead, always use a safety cable. Mount the product securely to a
rigging point, whether an elevated platform or a truss.
•
When rigging the product onto a truss, use a mounting clamp of appropriate weight capacity.
•
When power linking multiple products, mount the products close enough for power linking cables to reach.
•
The bracket adjustment knobs allow for directional adjustment when aiming the product to the desired
angle. Only loosen or tighten the bracket knobs manually. Using tools could damage the knobs.
Procedure
The COLORado PXL Bar 16 comes with a bracket to which you can attach a mounting clamp directly.
Mounting clamps are sold separately. Make sure the clamps are capable of supporting the weight of this
product. Use at least one mounting point per product. For the CHAUVET Professional line of mounting
clamps, go to http://www.trusst.com/products.
Mounting Diagram
Mounting clamp
Page 6 of 40
section of this manual provides detailed instructions on how to configure
for weight information.
Safety cable
Omega bracket
COLORado PXL Bar 16 User Manual Rev. 1
Setup
Safety
Notes.
Advertisement
Table of Contents
