Table of Contents
Advertisement
3. S
ETUP
AC Power
This fixture runs on 115V or 230 VAC, 50/60 Hz. Before powering on the unit, make sure the line
voltage to which you are connecting it to matches the current selection on the voltage selection
switch.
Always connect the fixture to a switched circuit. Never connect the fixture to a rheostat
(variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used only as a 0
to 100% switch.
Always connect the fixture to a circuit with a suitable electrical ground.
The maximum quantity of fixtures that may be linked is 4.
Power Linking
This fixture contains power linking via the edison outlet located in front of the power input cable.
Please see the diagram below for further explanation.
4. Operating Instructions
8
Additional power
link out
10/9/2009 2:29 PM
Advertisement
Table of Contents
