First Time Installation; General Information; The "First Time Installation" Menu; Language - Nokia Mediamaster 210 Owner's Manual

FIRST TIME INSTALLATION

General information

Once you have correctly connected the Mediamaster, you also
have to perform a "First time installation." During this procedure,
helpful information is displayed at the bottom of the menus.
Please note!
The select button always confirms a selection within these
menus, and pressing it will take you to the next step in the instal-
lation process. However, and this is important, often more than
one value has to be entered in a menu. First, perform all neces-
sary settings on the different lines. Then, confirm them all simul-
taneously by pressing select.
You can always go back to the previous menu by pressing back.
Use cursor up/cursor down to move upwards and downwards
from one line to another.
Use cursor left/cursor right to change settings.
You can also use the numeric buttons on the remote control to
enter numeric values.

The "First time installation" menu

This picture indicates that you have started the installation pro-
cedure.
• Plug in your Mediamaster.
• The "First time installation" menu is shown.
• Press select to continue.

Language

• Select the desired menu language with cursor up/cursor
down.
This will also become the main language for audio and subti-
tling.
• Press select to continue.

Antenna/satellite selection

• Select alternative "One antenna/one LNB configuration" if you
have a single antenna equipped with one LNB for receiving sig-
nals.
• Select alternative "Multisatellite/DiSEqC switch configuration"
if you have one antenna with two or four LNBs or two anten-
nas with one or two LNBs each for receiving signals from a
combination of satellites. In these cases you need a 2-way or
a 4-way DiSEqC switch.
• Select alternative "Motor antenna configuration" if you have
an antenna motor to control your satellite antenna.
GB 15