First Time Installation; General Information; The "First Time Installation" Menu; Language - Nokia MEDIAMASTER 9460 S Owner's Manual

FIRST TIME INSTALLATION

General information

Once you have correctly connected the Mediamaster, you also have to perform a
"First time installation."
During this procedure, helpful information is displayed at the bottom of the menus.
Please note!
The select button always confirms a selection within these menus, and pressing
it will take you to the next step in the installation process. However, and this is im-
portant, often more than one value has to be entered in a menu. First, perform all
necessary settings on the different lines. Then, confirm them all simultaneously
by pressing select.
You can always go back to the previous menu by pressing back.
Use cursor up/cursor down to move upwards and downwards from one line to
another.
Use cursor left/cursor right to change settings.
You can also use the numeric buttons on the remote control to enter numeric val-
ues.

The "First time installation" menu

This picture indicates that you have started the installation procedure.
• Press select to continue.

Language

• Select the desired menu language with cursor up/cursor down.
This will also become the main language for audio and subtitling.
• Press select to continue.

Antenna/satellite selection

• Select alternative "One antenna/one LNB configuration" if you have a single an-
tenna equipped with one LNB for receiving signals.
• Select alternative "Multisatellite/DiSEqC switch configuration" if you have one
antenna with two or four LNBs or two antennas with one or two LNBs each for
receiving signals from a combination of satellites. In these cases you need a 2-
way or a 4-way DiSEqC switch.
• Select alternative "Motor antenna configuration" if you have an antenna motor
to control your satellite antenna.
GB 12