Table of Contents
Advertisement
First time installation
General information
Once you have correctly connected the Mediamaster, you will
also have to perform a "First-time installation." During this pro-
cedure, helpful information is displayed at the bottom of the
menus.
Please note!
The select button always confirms a selection within these
menus, and pressing it will take you to the next step in the instal-
lation process. However, and this is important, more than one
value often has to be entered in a menu. Firstly, make all neces-
sary setting changes. Then, confirm them all simultaneously by
pressing select.
You can always return to the previous menu by pressing back.
Use the cursor up/cursor down button to move upwards and
downwards from one line to another.
Use the cursor left/cursor right button to change settings.
You can also use the numeric buttons on the remote control to
enter numeric values.
The "First-time installation" menu
This picture indicates that you have started the installation pro-
cedure.
• Plug in your Mediamaster.
• The "First-time installation" menu is shown.
• Press select to continue.
Language
• Select the desired menu language using the cursor up/cursor
down button.
This will also become the main language for audio and subti-
tling.
• Press select to continue.
Antenna/satellite selection
• Select the "One antenna/one LNB configuration" alternative
if you have a single antenna equipped with one LNB for receiv-
ing signals.
• Select the alternative "Multisatellite/DiSEqC switch configu-
ration" alternative if you have one antenna with two or four
LNBs or two antennas with one or two LNBs each for receiv-
ing signals from a combination of satellites. In this cases you
will need a 2-way or a 4-way DiSEqC switch.
• Select the "Motor antenna configuration" alternative if you
have an antenna motor to control your satellite antenna.
GB 17
Advertisement
Table of Contents
