FIRST TIME INSTALLATION
Advanced manual search
The information you need to enter in this menu is available in
magazines covering satellite TV reception or on the Internet.
You can use this menu if you are looking for some "special" chan-
nels (i.e. non-DVB standard channels) which can only be found
when you have entered the necessary settings here.
Transponder frequency: Specify the frequency in MHz.
Polarisation: Select Horizontal, Vertical, Circular left or right.
Symbol rate: Enter symbol rate with the numeric buttons.
PID Video: Enter the PID (Packet Identifier) for the video signal.
PID Audio: Enter the PID for the audio signal.
PID PCR: Enter the PID for the PCR (Programme Clock Refer-
ence).
Adjust motor: This alternative will only be visible if you have
made a motor antenna configuration. Adjust (if necessary) the
motor for the current satellite.
• Press select to tune with given parameters.
All channels created with advanced manual search will get an au-
tomatically generated name, e.g. P0001 for the first channel,
P0002 for the second etc.
• Press select to save the new channel or back if you don´t want
to save it.
Channel search in progress
This menu will be shown as long as the Mediamaster is search-
ing for TV and radio channels.
All channels found will be listed on the screen.
Please note that the search procedure may take a few minutes.
You can cancel the search at any time by pressing select.
When the search procedure has ended, a message will tell how
many TV and radio channels have been found.
• Press select to continue.
Time adjustment
The time is adjusted by using cursor up/cursor down, ± 1/2 an
hour at a time. You can also adjust the minutes by using cursor
left/cursor right.
• Press select to finish the first time installation and to open the
Navi™ Bars Navigator.
GB 20