Table of Contents
Advertisement
NAVI™ BARS NAVIGATOR
Settings folder
To open this menu you will be asked to enter your access code.
From the factory the access code is set to 1234.
The following settings can be altered from this menu.
Access Control
Select "Yes" or "No" to turn the access control in all menus on
or off. Note: Even when "No" is selected, the access code still
has to be entered before you can watch locked channels.
Receiver lock
If you select "Yes" you will have to enter the access code every
time you start the Mediamaster from standby.
Age rating control
If you want everybody to have access to all available types of pro-
grammes, select "No"
If you select "Yes" you may block programmes unsuitable for chil-
dren.
Age Limit
Select an age limit between 3 and 18 years on the line that ap-
pears.
However, you should be aware that not all Service Providers have
the necessary codes for these functions implemented in their
transmissions.
Change access code
From here you can change the access code from the stand-
ard 1234. DO NOT FORGET IT! Without it you do not have ac-
cess to any of the functions where the code is required!
Settings folder
To open this menu you will be asked to enter your access code.
From the factory the access code is set to 1234.
The time is adjusted by using cursor up/cursor down, ± 1/2 an
hour at a time. You can also adjust the minutes by using cursor
left/cursor right.
GB 30
☛
Access ctrl
☛
Time
Advertisement
Table of Contents
