Sole Fitness F63 Owner's Manual page 28

CALIBRATION PROCEDURE
1. Remove the safety key
2. Press and hold down the Start and Fast (speed up) buttons and replace the safety key. Continue to hold
the Start and Fast key until the window displays "Factory settings", then press the enter key.
3. You will now be able to set the display to show Metric or English settings (Miles vs. Kilometers). To do this,
press the up or down key to show which you want, then press enter.
4. Make sure the wheel size diameter is 2.30 then press enter
5. Adjust the minimum speed (if needed) to
6. Adjust the maximum speed (if needed) to
7. Adjust the maximum elevation (if needed) to 15 and then press enter
8. Grade return – On (This allows the incline to return to zero when stop is pressed. For sale in
Europe, Eu standards require this to be off.
9. Press start to begin calibration. The process is automatic; the speed will start up without warning, so
do not stand on the belt.
ADJUSTING THE SPEED SENSOR
If the calibration does not pass you may need to check the speed sensor
alignment.
1. Remove the motor cover hood by loosening the 4 screws that hold it in
place (you do not need to remove them completely).
2. The speed sensor is located on the left side of the frame, right next to the
front roller pulley (the pulley will have a belt around it that also goes to the
motor). The speed sensor is small and black with a wire connected to it.
3. Make sure the sensor is as close as possible to the pulley without touching
it. You will see a magnet on the face of the pulley; make sure the sensor is
aligned with the magnet. There is a screw that holds the sensor in place that needs
to be loosened to adjust the sensor.
Re-tighten the screw when finished.
MAINTENANCE MENU
1. Remove the safety key
2. Press and hold down the Start and Slow keys and replace the safety key. Continue to hold
the Start and Slow keys until the SW ver. Prompt appears in the message window. Release the keys and press
the Slow key to enter the menu.
3. Use the Fast and Slow keys to scroll through the menu, enter key to select and stop key to return to previous.
a. Key tone – Turns the speaker
0.5 mph/ 1.0 kmph
10.0 mph / 16 kmph
on or off so there is no beeping sound.
26
and then press enter
and then press enter