Service Checklist - Diagnosis Guide - Sole Fitness F63 Owner's Manual

SERVICE CHECKLIST – DIAGNOSIS GUIDE
Before contacting your dealer for aid, please review the following information. It may save you
both time and expense. This list includes common problems that may not be covered under the
treadmill's warranty.
PROBLEM
Display does not light
Tread-belt does not stay centered
Treadmill belt hesitates when
walked/run on
Motor is not responsive after pressing
start
Treadmill will only achieve
approximately 12 kmph (7 mph)
shows
higher speed on display
Tread-belt stops quickly/suddenly
when tether cord is pulled
Treadmill trips on board
Computer shuts off when console is
touched (on a cold day) while
walking/running
House circuit breaker trips, but not
the treadmill circuit breaker
SOLUTION/CAUSE
1. Tether cord not in position.
2. Circuit breaker on front grill tripped.
Push circuit breaker in until it locks.
3. Plug is disconnected. Make sure plug is firmly pushed
into AC household wall outlet.
4. Household circuit breaker may be tripped.
5. Treadmill defect. Contact your dealer.
The user may be walking while favoring or putting more weight
on either the left or right foot. If this walking pattern is natural,
track the belt slightly Off-center to the side opposite from the
belt movement. See General Maintenance section on
Tread-belt Tension Adjust as necessary.
If the belt moves, but stops after a short time and the display
shows "LS", run calibration.
If you press start and the belt never moves, then the display
shows LS, contact service.
This indicates motor should be receiving power to operate. Low
AC voltage to treadmill. Do not use an extension cord. If an
but
extension cord is required it should be as short as possible and
heavy duty 16 gauge minimum. Low household voltage.
Contact an electrician or your dealer. A minimum of
current is required.
High belt/deck friction. See General Maintenance section on
lubrication.
High belt/deck friction. See General Maintenance
15 amp circuit
Treadmill may not be grounded. Static electricity is "crashing"
the computer. Refer to Grounding Instructions.
Need to replace the house breaker with a "High Inrush current"
type breaker.
25
230 volt AC