Table of Contents
Advertisement
Refer to the nameplate on the front of the appliance.
•
Verify the ELECTRICAL SERVICE POWER.
•
Voltage and phase must match the nameplate specifications, and
available electrical service amperage must meet or exceed the
specifications listed on page 1.
•
Wiring must be no less than 1.5 mm solid copper wire, rated for at
least 90ºC.
Wire gauge, insulation type and temperature rating , as well as type,
size and construction of conduit, must meet or exceed applicable
specifications of local electrical codes.
The EARTH ground lug is inside the right side access panel, and must
be connected to a suitable earth ground. The POTENTIAL ground
connection is on the back of the cabinet, and must be connected to
other electrical appliances in the room.
The appliance is shipped from the factory wired for 380-415 volt
3-phase plus Neutral and Ground electrical service.
IMPORTANT: This appliance is designed for 3ø operation only.
DANGER: ELECTRICAL SHOCK HAZARD
ELECTRICAL CONNECTIONS MUST BE MADE BY A
LICENSED ELECTRICIAN
Electrical shock will cause death or serious injury.
7
INSTALLATION (continued)
CAUTION:
RISK OF
DAMAGE
DO NOT connect or energize
this appliance until all
installation instructions are
read and followed. Damage
to the appliance will result if
these instructions are not
followed.
CAUTION:
ELECTRICAL
SHOCK HAZARD
The ground lug of this
appliance must be connected
to a suitable building ground.
IMPORTANT:
Contact a licensed electrician
to install and connect
electrical power to the
appliance.
IMPORTANT:
Damage due to being
connected to the wrong
voltage or phase is NOT
covered by warranty.
Advertisement
Table of Contents
