Rear Panel - Korg SGPROX Owner's Manual

Stage piano / controller
Table of Contents

Advertisement

B VALUE slider
When editing, use this slider to specify the values
of various settings.
C VALUE switch ( +1/YES -1/NO )
In Program mode and Performance mode, the pro-
gram or performance will change in steps of one
each time these switches are pressed.
When editing, use these switches to adjust the value
of various settings.
These switches are also used to answer "YES" or
"NO" in response to an "OK?" prompt that appears
in the LCD.
By pressing both switches simultaneously, you can
bring back the original value that was specified
when you selected that parameter (the UNDO func-
tion).
D Mode switches ( 5)
Use these switches to change modes.
The LED of the selected mode switch will light.
(In the case of GLOBAL mode it will blink.)
GLOBAL mode (
PERFORMANCE EDIT mode (
PROGRAM EDIT mode (
PERFORMANCE mode (
PROGRAM mode (
E Select switches (8
Use these switches to select programs, perfor-
mances, and edit displays.
The LED of the selected switch will light or blink.

Rear panel

F Power switch
Press this switch to turn the power on or off.
G Music stand holes
The music stand (included) can be attached here.
F
p.27)
p.38)
p.33)
p.26)
p.25)
2)
G
H MIDI connectors (6 connectors)
IN:
This connector is used for MIDI re-
ception
OUT A: These connectors transmit data from
the SGproX. They transmit data of
channels A1 to A16. The two con-
nectors transmit the same data.
OUT B: These connectors transmit data
from the SGproX. They transmit
data of channels B1 to B16. The two
connectors transmit the same data.
THRU: The MIDI data received at MIDI IN
is re-transmitted without change
from this connector.
I Other jacks
Assignable pedal switch jack (AS)
A foot switch can be connected here. You can
specify the function of the switch (
You will need to specify the polarity of the
foot switch that you use (
Assignable pedal jack (AP)
A continuous pedal (XVP-10 is recom-
mended) can be connected here. You can
specify the function of the pedal (
Damper jack
If an optional Korg DS-1H is connected here,
it can function as a half-damper pedal.
If a DS-1 is connected, it will function as a
damper switch.
You will need to specify the polarity of the
damper switch that you use (
If you want the operation of a half-damper
pedal to be more precise, you will need to
make an adjustment (
J OUTPUT (two)
L/MONO: When stereo connections are
used, the left channel signal is
output from this jack. When lis-
tening in monaural, only connect
this jack.
R:
When stereo connections are
used, the right channel signal is
output from this jack. When lis-
tening in monaural, do not use
this jack.
Introduction
p.55).
p.28).
p.55).
p.28).
p.32)
H
I
J
13 13

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents