Turn On The Power - Korg SGPROX Owner's Manual

Turn on the power

1) With VOLUME 1 lowered, press the POWER switch 2 located on the rear panel to turn on the
power.
2) The PROGRAM and PIANO1 LEDs 3 will light, and you can now play the keyboard to hear the
PIANO1 sound.
3) Press one of the sixteen switches 3 that indicate names of various sounds. The LED of that switch will
light, and the sound will change.
4) Press the BANK switch 4, and the bank will change in the order of A
you to select from four sounds of the same category.
5) Use the VOLUME and EQUALIZER sliders 1 to adjust the volume and tone to your taste.
ASSIGNABLE WHEEL
AW1 AW2
2
POWER switch
AC cable
(included)
Connect to
an AC outlet
1 4
EQUALIZER ASSIGNABLE SLIDER
VOLUME LOW LOW-MID MID HIGH-MID HIGH AL1/A AL2/a AL3/0 AL4/!
SPLIT
LAYER EFFECT ON
SINGLE EFFECT OFF
MASTER TUNE
TRANSPOSE
BANK NORMAL
A a DELETE INSERT
3
ASGN.SW
VALUE CHANNEL LOCAL EX FILTER AFT.T FILT DAMP.P POL DATA DUMP
POL
GLOBAL
PROG PERF
CONTROLLER VEL CURVE A.T CURVE PAGE MEM SYS NAME
PROTECT PROTECT
SW/
TIMBRE SEL PROGRAM LEVEL PITCH PANPOT ZONE
CHANNEL
PERF EDIT
CONTROLLER VEL CURVE A.T CURVE TIMB COPY CTRL COPY MACRO RENAME
BRIGHTNESS LEVEL ATTACK DECAY RELEASE KEY TOUCH FX1 DEPTH
PROG EDIT
SCALE
FX1 TYPE FX1 PARAM FX2 TYPE FX2 PARAM PRELOAD RENAME
/BEND
PIANO1 PIANO2 PIANO3 E.PIANO1 E.PIANO2 E.PIANO3 PF LAYER
PERFORMANCE
CURSOR 1 2 3 4 5 6 7
9 10 11 12 13 14 15
PROGRAM
ORGAN1 ORGAN2 COMP BELL/VIBES STRINGS PAD1 PAD2
Introduction
B C D ..., allowing
MIDI RESET
CALIB
FILTER
WRITE
FX2 DEPTH
WRITE
E.P.LAYER
8
16
BASS
11