Modifying Antenna Settings (Diseqc) - TechniSat HDFS Owner's Manual

> For standard installations accept the antenna settings by pressing the
green accept key or the OK key.
> If the configuration of your receiving installation does not correspond
with the standard setting press the yellow key to select Modify. See
below for details.

8.1.1 Modifying Antenna Settings (DiSEqC)

This advanced screen allows you to change the configuration of your antenna.
> DiSEqC – You can toggle DiSEqC components in your receiving instal-
lation on or off by using the arrow keys or the OK key. Setting this op-
tion to 'off' will change the options below and only allow you to change
the default satellite.
> If you set DiSEqC to 'on' you will see the following options. Use the up/
down arrow keys to move to the options:
> A/A – Position A/Option A – Use the OK key to select the satellite you
wish to receive at the DiSEqC setting position A/A from the drop down
option list. If you want to configure the satellite, highlight 'Proceed'
using the arrow keys and press OK. See 8.1.2 for details.
> B/A – Position B/Option A – Use the OK key to select the satellite you
wish to receive at the DiSEqC setting position B/A from the drop down
option list. If you want to configure the satellite, highlight 'Proceed'
using the arrow keys and press OK. See 8.1.2 for details.
> A/B – Position A/Option B – Use the OK key to select the satellite you
wish to receive at the DiSEqC setting position A/B from the drop down
option list. If you want to configure the satellite, highlight 'Proceed'
using the arrow keys and press OK. See 8.1.2 for details.
19