TechniSat HDFS Owner's Manual page 98

15.2.4.5 Geo-positioning
If you have a suitable motor, and if the geographical coordinates of your loca-
tion are known, this function can facilitate finding the individual satellite posi-
tions.
Note! Only switch on the geo-positioning function if your DiSEqC motor
supports this function.
To set geo-positioning do the following:
> Use the arrow keys to move the highlight to the field labelled 'Geo. pos.
(off)' and press the OK key to display the popup below:
> Use the left/right arrow keys to switch the geo-positioning function 'on'
or 'off'.
> Use up/down arrow keys to highlight the 'E' or 'W' field, and use the OK
key to toggle between 'E' (East) and 'W' (West) to set the Longitude
value to either East or West.
> Use the arrow keys to select the 'Longitude' value field and enter the
geographical longitude with the number keys.
> Now use the arrow keys to highlight the 'N' or 'S' field and use the OK
key to toggle between 'N' (North) and 'S' (South) to set the Latitude
value to either North or South.
> Use the arrow keys to highlight the 'Latitude' value field and enter the
geographical latitude with the number keys.
> Press the Back key to return to the Antenna configuration screen.
The data relating to your location must be entered as a decimal value, correct
to one decimal place. As the coordinates are often stated in degrees, minutes
98