Appendix A - Led Status Patterns - SnapGear VPN Router User Manual

Appendix A – LED Status Patterns
The table below shows the various LED illumination combinations that serve to show possible error
conditions. In each case, the LEDs indicated will be on and steady, unless otherwise noted, and all other
LEDs will be off. The Power and System LEDs do not form part of the grouping of status-indicating
LEDs. Where the action indicates that you should contact your dealer, please take note of the LED pattern
to facilitate faster response and recovery action.
LED Pattern
VPN
COM2
All LEDs on
VPN & Internet Link
COM2 & Internet Link
Online
Appendix A – LED Status Patterns
Status
Memory failure
Console device cannot initialize
In recovery mode, usually from a
bad Flash image. While the reset
button is held in this will be the
LED pattern.
Cannot load static data into
memory, probably memory and/or
Flash problem
Cannot load SBSS, probably
memory and/or Flash problem
Memory exception
Action
Contact your dealer
Contact your dealer
Contact your dealer
Contact your dealer
Contact your dealer
91