Appendix A - Led Status Patterns - SnapGear VPN appliance Family 1.7.8 User Manual

Appendix A – LED status patterns
The following table shows the different LED illumination combinations that can indicate
possible error conditions.
In each case, the LEDs indicated will be on and steady, unless otherwise noted, and all
other LEDs will be off. The Power and System LEDs are not part of the LEDs indicating
status. Where the action indicates that you should contact your dealer, please note the
LED pattern to assist with faster response and recovery action.
LED Pattern
VPN
COM2
All LEDs on
VPN &and Internet
Link
COM2 and Internet
Link
Online
Appendix A – LED status patterns
Status
Memory failure.
Console device cannot initialize.
In recovery mode, usually from a bad Flash
image. While the reset button is held in this
will be the LED pattern.
Cannot load static data into memory,
probably memory and/or Flash problem.
Cannot load SBSS, probably memory and/or
Flash problem.
Memory exception.
Action
Please contact your
dealer.
Please contact your
dealer.
Please contact your
dealer.
Please contact your
dealer.
Please contact your
dealer.
95