COM 1, 2
VPN
The rear panel contains connector ports for LAN (LAN) and modem (COM1, COM2), LAN
10BaseT status LEDs, WAN 10BaseT status LEDs, a reset button and power inlet. The upper LEDs
represent "Link" condition, where a cable is connected correctly to another device (such as a cable
modem). The lower light represents "Activity" as per the front panel.
Introduction
Flashing
On
Figure 1.2
SnapGear VPN Router back panels
For either of the SnapGear VPN Router COM
ports, these LEDs indicate receive and transmit
data.
Virtual Private Networking is enabled.
8