Installing and configuring the SnapGear VPN Router
Instructions for installing and configuring your new SnapGear VPN Router on your network are
contained in this manual. The basic steps and related chapters are as follows:
Step
1. Interconnect the SnapGear VPN Router
and PCs on a local area network.
2. Connect the telecommunications
hardware/modem (for dial in/dial out
internet access).
3. Set up the network IP addresses and
firewall.
4. Set up Internet hardware and Internet
account and connect to the Internet.
5. Set up users' security dial-in/dial
out/VPN.
Introduction
See chapter:
Chapter 2, Getting Started
Chapter 3, Connect to the Internet
Chapter 2, Configuring the SnapGear VPN
Router on your network
Chapter 3, Connect to the Internet
Chapter 4, Dial-in server configuration
Chapter 7, Virtual Private Networking
Chapter 6, Filtering and Security Groups
6