Snapgear Quick Setup Wizard - SnapGear VPN Router User Manual

SnapGear VPN Router:ht=ethernet:ha=00d0cf000101:ip=192.168.0.1
•
You will need to modify the IP address (tag "ip") to match your local network's addressing.
Use an address in your local subnet. You will also need to modify the MAC address (tag
"ha") to match that of your SnapGear VPN Router hardware. It should be printed on a label
on the bottom of the SnapGear VPN Router box. You can optionally include gateway
("gw") and DNS ("ds" and "dn") tags as appropriate. See the manual page for bootptab if
you are unsure.
•
Save and exit the file.
3. Restart TCP/IP on your system. If you don't know how, then just reboot the Linux system. Once
the system is running it should serve the IP address to the SnapGear VPN Router when it is
connected to your network.

SnapGear Quick Setup Wizard

Once the initial network setup has been completed, all common configuration tasks can be carried
out through the web pages.
The SnapGear Quick Setup Wizard is provided to guide you through the basic steps to configure the
SnapGear VPN Router's LAN port and to connect to the Internet. To start the wizard, click on the
Quick Setup Wizard link in the middle of the SnapGear Management Console configuration
page. Modifying the configuration will require entering the SnapGear VPN Router's administrator
password. The username field will be ignored, as there is no username. The factory default
password is default.
Getting Started
18