Stereo Delay; Reverse Delay; Tape Echo; Chorus - Roland V-Drums TD-30 Owner's Manual

STEREO DELAY

This is a stereo delay.
Parameter Value
BPM Sync OFF, ON
Time Left
0–1300 msec, note
Time Right 0–1300 msec, note
Feedback -98–+98 %
Phase Left NORMAL, INVERSE Phase of the delay sound
Phase Right NORMAL, INVERSE Phase of the delay sound
Wet Gain Low -15–+15 dB
Wet Gain High -15–+15 dB

REVERSE DELAY

This is a reverse delay that adds a reversed sound of the
input sound as a delayed sound. A chorus is connected
immediately after the reverse delay.
Parameter Value
Threshold 0–127
BPM Sync OFF, ON
DlyTime 0–1300 msec, note
Feedback -98–+98 %
Explanation
OFF: Time specified as
numerical value
ON: Time specified as note
value
Adjusts the delay time
from when the direct
sound begins until the left
delay sound is heard.
Adjusts the delay time
from when the direct
sound begins until the
right delay sound is heard.
Proportion of the
delay sound that is to be
returned to the input.
Negative(-) settings invert
the phase.
Amount of boost/cut for
the effect sound's lower
range
Amount of boost/cut for
the effect sound's upper
range
Explanation
Volume at which the
reverse delay will begin to
be applied
OFF: Reverse delay time
DlyTime specified as
numerical value
ON: reverse delay time
DlyTime specified as note
value
Delay time from when
sound is input into the
reverse delay until the
delay sound is heard
Proportion of the
delay sound that is to
be returned to the input
of the reverse delay.
Negative(-) settings invert
the phase.

TAPE ECHO

Simulates a tape-type echo unit of the past.
Parameter Value
Rate
0–127
Intensity 0–127

CHORUS

This is a stereo chorus. A filter is provided so that you can
adjust the timbre of the chorus sound.
Parameter Value
PreDelay 0.0–100 msec
Rate 0–127
Depth 0–127
Phase 0–180 deg
Filter Type OFF, LPF, HPF
Cutoff 200–8000 Hz

PHASER

A phase-shifted sound is added to the original sound
and modulated.
Parameter Value
4-STAGE, 8-STAGE,
Mode
12-STAGE
Manual 0–127
Rate 0–127
Depth 0–127
Resonance
0–127
Effects
Explanation
Tape speed
Amount of echo repeat
Explanation
Adjusts the delay time
from the direct sound
until the chorus sound is
heard.
Frequency of modulation
Depth of modulation
Spatial spread of the
sound
Type of filter
OFF: no filter is used
LPF: cuts the low
frequency range
HPF: cuts the high
frequency range
Center frequency when
using the filter to cut a
specific frequency range
Explanation
Number of stages in the
phaser
Adjusts the basic
frequency from which the
sound will be modulated.
Frequency of modulation
Depth of modulation
Amount of feedback
73