(Control); Playing A Pattern By Striking A Pad (Pad Pattern) (Pattern) - Roland V-Drums TD-30 Owner's Manual

Instrument
Using the Pads to Control the
Pattern or Sound (CONTROL)
Lets you use a pad or pedal to play a pattern or modify
the sound.
1.
Press the [INST] button .
2.
Press the [F3] (CONTROL) button .
3.
Select the pad that you want to edit .
Strike the desired pad, or use the TRIG SELECT buttons
to select it.
The edit screen for the selected pad will appear.
4.
Press the [F1]–[F5] and cursor [ ] [ ] buttons to
select the parameter .
5.
Use the [F1]–[F5] buttons to select the setting
that you want to make .
Button
[F1] (PATTERN) button
[F2] (PDLBEND) button
[F3] (POSI) button
[F5] (MIDI) button
6.
Use the [–] [+] buttons or the dial to adjust
settings .
7.
When finished, press the [EXIT] button to return
to the INST screen .
Playing a Pattern by Striking a Pad
(Pad Pattern) (PATTERN)
The Pad Pattern function starts playback of a pattern
when a pad is struck. This function provides a
very convenient way to use patterns during a live
performance.
If different patterns have been assigned to two or more
pads, striking another pad while a pattern is playing
back will cause pattern playback to switch to the newly
selected pattern.
60
Explanation
Lets you play a pattern by striking
a pad.
Specifies the amount of pitch
change that will be controlled by
the depth to which you press the
hi-hat pedal.
Enables/disables tonal changes
controlled by the strike position.
Lets you make MIDI settings.
* The performance of a pattern played back by the
pad pattern function cannot be recorded into the
sequencer.
Parameter Value
PadPtn
OFF, ON
Master Sw
OFF, P1–P100,
Pad Ptn
U101–U200
OFF
Pad Ptn
Velocity
ON
Tap Ptn Mute
OFF, 1–8
Grp
MEMO
For more about patterns, refer to "Pattern Sequencer"
(p. 89).
Explanation
Specifies whether the
Pad Pattern function will
be used (ON) or not used
(OFF).
Selects the played back
pattern when the pad is
struck.
If all pads are set to "OFF, "
icon appears.
The pattern plays back
at the velocity set for the
pattern, regardless of the
strength with which the
pad is struck.
The pattern plays back
with the velocity changing
in response to the
strength with which the
pad is struck.
This setting is enabled
only if a pattern whose
Play Type is "TAP" (p. 98) is
assigned to multiple pads.
If one sound (pattern)
is set to play before the
previous sound (pattern)
has finished playing, this
setting allows you to
either have the previous
sound stop and the
subsequent sound start
playing or have the two
sounds layered.
• Patterns set to the same
number
The previous sound
stops while in progress,
and the subsequent
sound (pattern) starts
playing.
• Patterns set to the
different numbers
The previous sound
continues to play to the
end, while the subsequent
sound (pattern) is
superimposed on it.