Table of Contents
Advertisement
7.
loosen the belt tilt lock handle and remove
the two belt tilt lock knobs (figure 42).
lock Knob (1 of 2)
figure 42. Tilt lock handle and lock knobs.
8.
use the belt tilt handle to tilt the entire belt
assembly (figure 43).
figure 43. Tilting belt assembly.
9.
replace the belt tilt lock knobs into the edge
sanding position (figure 44).
lock Knob in
Edge sanding
position
figure 44. Lock knobs in edge sanding position.
-26-
tilt handle
tilt handle
10. pull the table all the way forward, lock it in
place with the table travel locks, then use the
table elevation handwheel to raise the table
until it is even with the belt (figure 45).
table Elevation handwheel
figure 45. Elevating table.
NOTICE
if you try to raise the table to the top edge
of the belt, the table and belt assembly will
bind and may damage the machine. Do not
attempt to force the table above the midline
of the belt.
11. position the table workstop on the right side
of the table and the auxiliary work stops on
the right side of the base.
g0679 stroke/Edge sander
table Even
With Belt
Advertisement
Table of Contents
