Grizzly G0679 Owner's Manual page 18

5.
Connect the table elevation rod to the left
and right side elevation assemblies. place
the notch in the end of the rod against the
notch in the shaft at the base of the eleva-
tion assembly, slide the coupler over the
joint, then tighten the set screw, as shown in
figure 15.
Note: To make sure both sides are set
evenly, fully lower both before connecting the
table elevation rod.
set screw
table Elevation rod
figure 15. Table elevation rod.
6.
With the help of an assistant, place the platen
assembly onto the assembled frame, as
shown in figure 16.
platen assembly
figure 16. Platen assembly.
-16-
Coupler
assembled Frame
7.
secure the motor and platen assembly with
the pivot bolts, lock nuts, platen lock knobs,
and ⁄ " flat washers, as shown in figure 17.
1
2
figure 17. Pivot bolt, nut, and knob.
8.
assemble the lock bracket by placing the
bracket over the stud and securing it with the
⁄ "-13 lock nut, then inserting the lock handle
1
2
through the bracket slot and into the threaded
hole, as shown in figure 18.
figure 18. Lock bracket.
g0679 stroke/Edge sander
platen lock Knob
and Flat Washer
pivot Bolt & lock nut