Machine Leveling - Grizzly G0679 Owner's Manual

21. attach the auxilliary workstop rods by thread-
ing the workstop rods into the machine base,
then sliding the workstops over the rods and
tightening the knobs. (figure 31).
Workstop
Knobs
figure 31. Auxiliary workstops.
22. thread the belt tilt lever into the platen
assembly, as shown in figure 32.
figure 32. Belt tilt lever.
-20-
Workstop
rods
Belt tilt
lever

Machine Leveling

once assembly is complete, move your machine
into position, then level it. use a level to check
from side-to-side and front-to-back.
to adjust for level from side-to-side, use shims
under the rear feet of the machine.
to level from front-to-back, use the leveling feet.
thread each foot in or out as necessary, then
tighten the jam nut to secure it in position (figure
33).
rear Foot
figure 33. Machine leveling.
g0679 stroke/Edge sander
leveling Foot