Table of Contents
Advertisement
Programming Parameters
Compact Readout Programming Parameters are listed below. Values in [ ]
are the available range of values that may be programmed for that
parameter.
Factory defaults are shown in
Pr 1 – Datum Key Value
This value will be recalled and displayed when the
during normal operation (not during programming).
Default = 0
Pr 2 – Reading Direction
This parameter controls the direction of measurement (positive vs negative)
when the measuring system is moved.
Default = 0
Pr 3 – Key Lockout
This parameter controls the operation of the +,
(set to 1), these keys will not function and the
the readout. This prevents accidental changes when depressing these keys
during normal operation.
Default = 0
Pr 4 – Resolution
This parameter sets the number of places to the right of the decimal point on
the readout.
A value of 1 will display x.x.
A value of 2 will display x.xx
A value of 3 will display x.xxx
Default = 2
NOTE:
Decimal inch mode has a maximum of 3 places.
Millimeter mode has a maximum of 2 places (even if parameter is set to 3.)
Fractions mode is not affected by this setting.
Manual Part # 800-1404-001, Rev B
Bold Red.
[0
to + 999.999in] or
[0
to +9999.99mm]
key is pressed
DATUM
[0
or 1]
[0
or 1]
-
and
keys. If enabled,
DATUM
LOCK
symbol will appear on
[1,
2
or 3]
Page 34 of 36
Advertisement
Table of Contents
