Table of Contents
Advertisement
Changing the Batteries
A low battery indicator will appear in the lower left corner of the LCD. When
battery voltage drops below approximately 2.6V the readout will turn itself off
until the batteries are replaced.
To replace the battery remove the screws in the upper right and lower left
corners. Pull the cover off. Remove the old batteries. Reinstall 2 new AA
Alkaline batteries, noting the proper orientation. Replace the cover and
tighten the screws.
CAUTION: DO NOT BEND THE BATTERY CLIPS!
THESE CLIPS ARE DESIGNED TO BE LOOSE WHEN THE CASE
IS OPEN AND WILL COMPRESS AND SECURE THE BATTERIES
IN PLACE WHEN THE CASE HALVES ARE SCREWED TOGETHER.
Calibration
There is no calibration available or necessary for the DIGI readout.
System accuracy will depend on the accuracy of the DigiScale and the
quality of the installation.
Manual Part # 800-1404-001, Rev B
Page 16 of 36
Advertisement
Table of Contents
