Table of Contents
Advertisement
4
SECTION
Several functions of the Readouts are user programmable. The following
section describes how to change factory defaults to customize your DRO.
To enter Programming Mode:
1. Press and hold the
2. The LCD will briefly display: PG
Pr
Pr
1, (indicating Programming Parameter #1)
1
Pr
Pr
1
1
3. Release the
4. The value stored for
Once in the Programming Mode:
Moving up parameter list - Momentarily press the
through the Programming Parameter list, first displaying the Programming
Parameter number then the currently programmed value.
Moving down parameter list - Press and hold the
momentarily press the
Programming Parameter list.
Increase parameter value - Momentarily press the
displaying a Programming Parameter Value to increase the parameter
setting.
Decrease parameter value - Momentarily press the
displaying a Programming Parameter Value to decrease the parameter
setting.
Reset parameter value to default setting - Momentarily press the
while displaying a Programming Parameter Value to reset the parameter to
the factory default value.
Exit programming mode - Press and hold the
depress the
DATUM
(Programming Off), then return to normal operation. NOTE: The system will
automatically exit programming mode after 60 seconds of no key activity.
Accurate Technology ProScale Model 18W
key then momentarily press the
UNITS
key
UNITS
is displayed.
Pr1
Press & Hold
UNITS
key. The LCD will briefly display: PG
PG
PG
PG
on (Programming On), then
on
on
on
key to move backward through the
UNITS
PROGRAMMING
DATUM
Momentarily press
key to advance
UNITS
/
ON
OFF
(+)
PLUS
-
(
)
MINUS
DATUM
key. Momentarily
PG
oFF
oFF
PG
PG
oFF
oFF
Page 17 of 20
key.
key and
key while
key while
key
Advertisement
Table of Contents
