Key Lock; Resolution; Restore Readout To Factory Settings - Accurate Technology DigiScale 18 User Manual

KEY LOCK

To activate the Key Lock function press and hold the
momentarily press the
corner of the readout. When LOCK
become inactive to prevent accidental changes of the (calibrated) current
displayed position. To de-activate the Lock function, press and hold the
/ key and then momentarily press the
ON OFF
NOTE: The Lock function can also be enabled/disabled through
programming. This allows a more permanent Lock function since
programming can be disabled with a hardware jumper inside the readout thus
preventing any front panel programming changes.
See Section 3: Programming,

RESOLUTION

The readout can be configured to display measurements in any of three
different resolutions.
1. Low– the resolution is:
2. Normal– the resolution is:
3. High– the resolution is:
The display of fractions remains the same for all settings: 1/16, 1/32 & 1/64
See Section 3: Programming,

RESTORE READOUT TO FACTORY SETTINGS

Press and hold the
turned off. This will perform a full segment LCD test, display the current
firmware version, and reset all programming parameters to factory defaults.
Accurate Technology DigiScale Models 18 & 28 User Manual
key. The word LOCK
UNITS
LOCK is displayed, the +,
LOCK LOCK
Programming Parameter Pr3.
Programming Parameter Pr4.
/ and
ON OFF UNITS
LOCK will appear in the upper left
LOCK LOCK
key.
UNITS
.1in or .1mm.
.01in or .01mm.
.001in or .01mm
keys for 10 seconds with readout power
/ key and then
ON OFF
and –
DATUM
Page 21 of 36
keys